 | DiveUS.com |
Keywords: Upgrade, any, primary, light, to, E/O, cords
E/O Underwater Pluggable connectors
Wetmates E/O cords are an available option that adds flexibility and modularity
to any Halcyon lighting system. These underwater pluggable connectors are
standard equipment on all Halcyon video systems.
E/O cords offer great advantages in flexibility; however, they require some
minor attention to ensure reliable service. Over time the rubberized connectors
may loosen and weaken the connection. The problem is easily solved by placing
the connector on a hard surface and firmly hitting it with a rubber mallet. This
action will tighten the connector and prevent a sloppy connection. The only
other problem that might occur is a slight oxidation on the connector tip after
several dives in salt water. A light sanding with extra fine sand paper will
remove any oxidation and ensure a good connection.
When used with a halogen bulb, an improper E/O connection will cause the light
to flicker. With an HID lamp, an improper connection will cause the light to go
out should the voltage drop below the level regulated by the ballast. The effect
is the same as if you had turned the light off with the switch: the ballast must
reset itself and the bulb cool before restriking. If your light should go off
because of a loose E/O connection, re-seat the connection and wait ten to twenty
seconds before restriking the lamp.
Buy >> Upgrade any primary light to E/O cords <<
<< Back
Related Products
| DiveUS.com |
Keywords: Upgrade, any, primary, light, to, E/O, cords